Quicksilver 875SD Owner's Manual page 70

Quicksilver 875SD — Electrical Systems
Shore power cord should be secured or routed to avoid
laying or falling in the water, and to avoid stress on the
shore power plug and inlet.
Turning Off and Disconnecting Shore Power
To disconnect shore power:
On the Boat
1. Make sure that the all of the breakers on the AC Distribution Panel are OFF
On the Dock
1. Turn OFF the dock breaker.
2. Disconnect the dockside end of the power cord.
On the Boat
1. Disconnect the power cord from the shore power receptacle.
2. Clean the power cord, spray the plugs with a moisture repellent and store the cord in a dry
location on the boat.
You must keep the shore power cord and plug ends clean and dry. This is especially necessary if your
boat is used in salt water. Always clean and spray your cord ends with moisture repellent before using
and before storing the cord.
AC Panel
The use of extension shore power cords is not
recommended. Power core extensions can cause a voltage
drop and prevent some devices from operating correctly.
Voltmeter
Reverse polarity indicator
Main breaker switch — 16 Amp
Main test button
Battery charger breaker switch — 10 Amp
Outlets breaker switch — 7 Amp
Cooktop breaker switch — 16 Amp
Air conditioner breaker switch — 10 Amp
Water heater breaker switch — 10 Amp
Microwave breaker switch — 6 Amp
58