Cockpit Table; Sun Lounge (Optional) - Quicksilver 875SD Owner's Manual

Quicksilver 875SD — System & Component Overview and Operation
To return the backrest to it's most up-right position, simply lift the lever again and rotate the seat back
up.
Reclining Aft Lounge Seat
Aft Lounge Seat — Upright Position
Aft Lounge Seat — 90 Degree Recline

25. Cockpit Table

Your boat comes equipped with a rectangular teak cockpit table. Also included are two removable
table legs, which when not in use, are stored on the cockpit floor access hatch. To install the table,
first remove the plastic covers located in the table base plates. Next, push and lock the table legs into
the base plates. Finally, place the table onto the table legs. The table is hinged to all easy access to the
L-lounge seating. When not in use, the table can be placed in a convenient bag and stored in the bilge.
26. Sun Lounge Conversion (optional)
As a supplement to the L-lounge seat in the cockpit, an optional sun lounge conversion is available.
This consists of two additional table legs and an upholstery cushion. When not in use, the two short
table legs are stored on the cockpit floor access hatch.
To install the sun lounge, first remove the plastic covers located in the table base plates. Next, push
and lock the short table legs into the base plates. Next, push and lock the short table legs into the
cockpit table. Now, place the table and table legs into the table bases in the cockpit floor. The table
will now sit in a lip located on the edge of the L-lounge. Snap the sun lounge cushion in place and
rotate the aft lounge backrest 90 degrees.
Do NOT run the boat while the aft cockpit seat is laying flat.
Quicksilver® recommends that when the engine is running,
the seat back is in it's most up-right position.
Aft Lounge Seat — 30 Degree Recline
47
Reclining lever