Navigation Lights - Quicksilver 905WE Owner's Manual

Quicksilver 905WE — General Information
Please note that operator vision from the helm may be obstructed by high trim angles of the craft,
along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load
distribution, speed & acceleration, transition from displacement to planing mode, sea conditions, rain
and spray, darkness and fog, interior lights, position of tops and curtains, and persons or movable
gear in the operator's field of vision.
Dash Switch Panel

17. Navigation Lights

Your boat comes equipped with navigation lighting for use at night or in low visibility conditions. Prior
to running at night, make sure that the all around light located on the hardtop is in the upright
position. A three position switch, located at the helm switch panel, controls the navigation lights. To
turn on the Navigation Lights, push the upper part of the switch forward. This illuminates on the port
(red), starboard (green) and all around light (white) showing other vessels that you are underway. To
turn on the Anchor Light, push the lower part of the switch down. This illuminates the all around light
(white), letting other boaters know that you are anchored at a given location.
Navigation light switch
Horn
Navigation lights
Forward bilge pump
Aft bilge pump
The International Regulations for Preventing Collisions at
Sea (COLREG) and the rules of the road require that a
proper lookout be maintained at all times and observance
of right of way be respected. Always be certain to have
sufficient distance to stop or maneuver if required to avoid
collisions.
Port wiper
Starboard wiper
Windshield washer fluid
Navigation Lights "OFF"
Navigation Lights "ON"
Anchor Light "ON"
16