StarTech.com ARMDUAL Manual page 7

Desk mount articulating dual monitor arm with cable management & height adjust

Table of Contents

3. Use the four hex screws that you removed in step 2 to install the grommet mount

(7) to the base of the pole.

4. Use a Phillips screwdriver to remove the screw and two washers shown, and

disconnect the threaded shaft from the base of the desk clamp (3). Slide the plate

back onto the shaft.

Instruction Manual

Table of Contents

Need help?

Do you have a question about the ARMDUAL and is the answer not in the manual?

8starmdual