Attaching A Monitor; Attaching The Monitor Mount - StarTech.com 8STWALLSTSI2 User Manual

Attaching a Monitor

Align the Mounting Hole (x 4) on the Monitor Mount with
1.
the mounting holes on the back of the Monitor.
Insert the Hand Screws through the Monitor Mount and
2.
into the back of the Monitor.
Using your fingers tighten the Hand Screws.
3.
Warning! Do not over-tighten the screws. If you encounter
resistance while you're tightening the screws, stop tightening.
Failure to do so could result in damage to the monitor.
Repeat steps 1 - 3 to attached the second Monitor.
4.

Attaching the Monitor Mount

Note: Attaching the Monitor Mount may require two
people.
The Monitor Mounts can support up to a maximum of 9 kg
per mount.
Align the Mounting Hole on the Swivel Arm w/ Logo with
1.
the Mounting Peg on the top of the Monitor Shoulder.
Slide the Mounting Hole on the Swivel Arm w/ Logo over
2.
the Mounting Peg until it clicks into place.
Align the Mounting Hole on the Spring Arm with the
3.
Mounting Peg on the top of the Swivel Arm w/ Logo.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
22