** Enter Setup
Timeout between Decodes:This parameter sets the timeout between decode sessions. When a decode
session ends, next session will not happen until the timeout between decodes expires. It is programmable
in 0.1s increments from 0.0s to 25.5s. The default timeout is 1.0s.
Example: Set the timeout between decodes to 5s
1.
Scan the Enter Setup barcode.
2.
Scan the Timeout between Decodes barcode.
Scan the numeric barcodes "5" and "0". (See the Digit Barcodes section in Appendix)
3.
4.
Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5.
Scan the Exit Setup barcode.
Exit Setup
Timeout between Decodes
48