ICP DAS USA LinPAC AM335 Series User Manual page 131

Step 3: Restart the LinPAC
Switch off the LinPAC and then restart it. Channel 0 on the I-87024W module will output 2 V.
Step 4: Confirm that the Power-on Value is functioning correctly
Use the multimeter to measure the channel output voltage on the I-87024W module and verify
that the voltage is the same as before the LinPAC was restarted.
Notes:
1. Use the DCON protocol to configure the I-87024W module. For more information about the
command set for the I-87024W module, refer to:
http://ftp.icpdas.com/pub/cd/8000cd/napdos/dcon/io_module/87k/aio/87024w_rw/dcon_87
k/87024_dcon_87k.htm
2. The address and baudrate for the LP-8x2x/9x2x are
fixed-parameters in the library and cannot be modified.
AM335X-PAC Series User Manual
Copyright © 2021 ICP DAS Co., Ltd. All Rights Reserved.
00 and 115200
version 2.0.4
respectively. They are
Page: 131
E-mail: service@icpdas.com