Advertisement
Q
u
Q
u
1
Shipping Package
This shipping package contains the following items:
1 x LP‐8121/8421/8821
1 x Screw Driver 2.4 mm
2
Preparations for Devices
Power supply +10~+30 V
DP‐665
Ethernet Hub. For example: NS‐205 (optional)
NS‐205
Make sure your PC has workable serial port and network settings.
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved.
i
c
k
S
t
i
c
k
S
t
1 x micro SD/SD adapter
http://www.icpdas.com/products/Accessories/power_supply/dp‐665.htm
http://www.icpdas.com/products/Switch/industrial/ns‐205.htm
a
r
t
f
o
a
r
t
f
o
1 x microSD card
1 x Quick Start (This Document)
. For example: DP‐665 (optional)
DC
E‐mail: service@icpdas.com
r
L
P
-
8
r
L
P
-
8
English / Mar 2017/ Ver 1.1
1 x Software CD
x
2
1
x
2
1
1
Advertisement
Table of Contents
Related Manuals for ICP DAS USA LP-8 21 Series
Summary of Contents for ICP DAS USA LP-8 21 Series
- Page 1 English / Mar 2017/ Ver 1.1 Shipping Package This shipping package contains the following items: 1 x LP‐8121/8421/8821 1 x microSD card 1 x Software CD ...
- Page 2 Hardware Introduction Power Indicator ttyS1: COM3 (RS‐232/RS‐485) Rotary Switch LP‐8421/LP‐8821 MicroSD Socket ttyS34: COM36 ttyO5: Console (RS‐232) (RS‐232) DIP Switch USB Terminal Block LP‐8421: I/O Slot x 4 LP‐8821: I/O Slot x 8 Ethernet Power Indicator LP‐8121 Rotary Switch MicroSD Socket VGA 1 Slot Terminal Block Ethernet USB Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved. E‐mail: service@icpdas.com 2 ...
- Page 3 Console/Ethernet Connection Connect both the LP‐8x21 and your computer through the “Console” or “LAN 1/2”. User can choose the terminal software (e.g., Putty or others) to connect the LP‐8x21. If user chose the COM1 (“Console”), user can set the baud rate “115200” to connect the device. Fig 4‐1: Console Connection 3. If user used the LAN 1/2, user can refer to below default network configuration, then using the terminal software (e.g., Putty or others) to connect the LP‐8x21. 192.168.0.1 LAN1 Netmask 255.255.255.0 192.168.0.2 LAN2 Netmask 255.255.255.0 ...
- Page 4 Network Configuration 1. After user follow Chapter 4 “Console/Ethernet Connection” to connect to the device bash terminal, user can change the default network setting. 2. If user wants to change the network configuration, user can use the Linux command “vi” to modify the configuration file “/etc/network/interfaces”. 3. Using the ‘#’ to mark the default configuration. Please refer to the Fig 5‐1: Fig 5‐1: network configuration 4. After user save the file and reboot device, user can use the new network configuration to connect to the LP‐8x21. ...
Need help?
Do you have a question about the LP-8 21 Series and is the answer not in the manual?
Questions and answers