Page 1
Version 1.2, 2011/01/20 What’s In the Box? LP-5K module microSD card Software Utility CD Screw Driver RS-232 Cable Preparing for start-up your LinPAC-5000 Power Supply: +10V ~ +30V (Ex: DP-665) http://www.icpdas.com/products/Accessories/power_supply/power_list.htm View of the LinPAC-5000 USB Port COM 1 (RS-232)(console)
The normal mode is the default mode of operation. Use this mode for more tasks and configurations. Programs also are executed in this mode. Quick mode The safe mode is used to skip the LinPAC-5000 boot screen form microSD/microSDHC card, so as to speed up the booting process. OS update mode The mode is a way used to update OS, and the Linux OS image was just suitable for the LP-5000 by ICP DAS.
Page 3
Connect the LinPAC-5000 and Windows PC The port is located on the right-upper corner on the LinPAC-5000. It is a standard RS-232 serial port, and it provides TxD, RxD, GND, non-isolated. Start HyperTerminal by clicking on ‘Start Programs Accessories Communications Hyper Terminal’...
Page 4
Turn on the power, and user should see a message appear on the screen, and the total process is completed. To login LinPAC-5000 by ‘getty’ command. root Password: root ICP DAS - 4 -...
Page 5
Connect the LinPAC-5000 and Linux PC Install HyperTerminal tool in Linux PC such as minicom, gtkterm, etc. Take minicom as an example, please refer to the following steps: Type ’minicom -s’ to configure COM1 port, and press down and select ‘Serial port setup’.( please set for 115200 bits per second, 8 data bits,...
Page 6
To login LinPAC-5000 by ’getty’ command. root Password: root ICP DAS - 6 -...
Page 7
Telent to LinPAC-5000 In HyperTerminal : >> In Linux PC : >> In Windows PC : ICP DAS - 7 -...
Get & Configure IP of LinPAC-5000 The LinPAC-5000 network setting includes two ways. One is DHCP and the other is “Assigned IP”. DHCP is the default setting after the LinPAC-5000 is produced and this way is easy for users. However, if your network system is without DHCP server, then users need to configure the network setting by using “Assigned IP”.