Important Safety Warnings For Installation - Avaya Definity Callmaster VI Installation And User Manual

IMPORTANT SAFETY WARNINGS
When this product is located in a separate building from the telephone
communications system, a line current protector MUST be installed at
the entry/exit points of ALL buildings through which the line passes.
Only one protector is needed at each installation point.
For 2-wire installations, the following is recommended:
Lucent Technologies 4-type protectors
ITW LINX LP-type protectors.
Lucent Technologies 3BIC (carbon block) or Lucent 3BEW (gas tube)
protectors are also acceptable in a 2-wire installation.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN CAUSE DAMAGE TO
THE TERMINAL OR CAUSE THE ASSOCIATED DEFINITY
PACK TO REMOVE POWER TO THE TERMINAL. IN EITHER CASE, THE
TERMINAL WILL NOT FUNCTION CORRECTLY.
For 2-wire operation, if you need to plug the voice terminal into a 4-pin
or 6-pin wall jack, instead of a standard 8-pin modular jack, see the
Modular Wall Jack Wiring table to ensure that the wires from the 4-pin or 6-pin
wall jack are connected to the correct pins on the terminal LINE jack.
Two-wire installations must have only PBX connections on pair 1.
This information applies to the CALLMASTER
FOR INSTALLATION
INSTALLATION WARNING
(for the CALLMASTER VI)
MODULAR WALL JACK WIRING
Pin
4
5
Name
Pair
BL-W
1
1 W-BL
®
VI.
Description
2-Wire (Tip)
2-Wire (Ring)
®
ECS CIRCUIT