Connecting The Headsets - Avaya Definity Callmaster VI Installation And User Manual

Connecting the Headsets

The CALLMASTER VI provides two 4-pin headset jacks. The following
Lucent headsets are compatible with the CALLMASTER VI:
Starset* Headpiece
Supra* Headpiece
Mirage* Headpiece
†
TriStar Headpiece
†
Encore Headpiece
The two headset jacks share the same volume setting. The headset
jacks are not labeled; they are located near the bottom front of the unit
on the right and left sides. See Figure 5 for an example of the headset
jack connections.
1. 4-Pin Connector
2. Quick Disconnect
To connect the headset, do the following steps:
1. Insert the 4-pin male connector end of the headset adapter cord
into the headset jack on either the right or left side of the
CALLMASTER VI.
2. Insert the quick disconnect end of the headset adapter cord into
the headset.
A handset with a custom cable will work if plugged into one of the
headset jacks. The handset is available as a D-Kit.
*Registered trademarks of Plantronics, Inc.
†Trademarks of Plantronics, Inc.
Figure 5: Connecting the Headset Jacks
8