Avaya Definity Callmaster VI Installation And User Manual page 13

Connecting the CALLMASTER VI to the PC
The CALLMASTER VI relays call information to and from the PC over
the Electronic Industry Association (EIA/TIA-574) cable. The PC uses
this interface to dial and provide a graphical user interface to the
DEFINITY ECS. See Figure 4 for an example of this connection.
1. EIA (labeled)
2. Connection to the CALLMASTER VI
3. EIA/TIA-574 Cable
4. Connection to a Serial COM Port on the PC
Figure 4: CALLMASTER VI to PC Connection
connect the CALLMASTER VI to the PC, do the following steps:
To
1. Insert the 9-pin male connector at one end of the EIA/TIA cable
into the female D-subminiature connector located in the back of
the CALLMASTER VI, labeled "EIA." Tighten both connector
retaining screws.
2. Insert the 9-pin female connector at the other end of the EIA/TIA
cable into an unoccupied COM port in the PC. Tighten both
connector retaining screws.
NOTE: Write down which COM port connection is being used,
because this information will be required during the software
installation process.
7