Table of Contents
Advertisement
REMOTE TRANSMITTER OPERATING INSTRUCTIONS
TO TURN ON THE APPLIANCE:
1. Press the ON/OFF button. The transmitter display will show all active icons on the screen.
2. Select the Thermostat Mode by pressing the Thermostat Key: OFF (meaning Manual
Mode), ON (meaning normal Thermostat) or Smart (meaning Smart Mode).
a. In OFF (Manual Mode), the appliance will ignite and start on HI.
b. In ON (Normal Thermostat Mode), the appliance will only ignite if the Set
Temperature is greater than the Room Temperature.
c. In SMART (Smart Mode), the appliance will only ignite if the Set Tempera-
ture is greater than the Room Temperature.
TO TURN OFF THE APPLIANCE, press the ON/OFF button.
MODE KEY: Pressing the MODE KEY toggles between the
various available functions: Flame Height, Fan Speed, Accent
Light Dimmer and Secondary Burner On/Off.
Flame Height: 6 flame height Levels are available. While the Flame Height
Icon is displayed, pressing the Up or Down button once will
increase or decrease the flame height by 1 of 6 increments. If
the flame height is at Level 1 and the Down button is
pressed, all burners will turn OFF. If in IPI mode, the pilot
light will also extinguish. If in Standing Pilot Mode, the pilot
f i r e - p a r t s . c o m
light will remain ON. Note: If in SMART model, the flame
height function is not available for manual adjustment. In
SMART mode, the flame height regulates automatically.
Fan Speed Control: The fan speed can be adjusted through six (6) speeds and
OFF. To activate this function, press the MODE Key to index to the
fan control icon. Use the UP/Down Arrow Key to turn ON, OFF or ad-
just the fan speed. A single "beep" will confirm reception of the com-
mand. Once you set the desired fan control, the system will remem-
ber your selected fan speed until you manually change it.
Accent-Light Dimmer: This function controls the Mendota Accent Light
functions. Pressing the UP key in this mode will TURN ON the Accent
Light and allow you to control the brightness of the Accent Light in 6
steps. A single "beep" will confirm reception of the command. Once
you set the desired light brightness, the system will remember your
selected brightness level until you manually change it.
Secondary Burner: This function controls the Secondary Burner's ON/OFF fea-
ture. Pressing the UP Key in this mode will TURN ON the Second-
ary Burner and Pressing the DOWN Key will TURN OFF the Sec-
ondary Burner. The flame level will not change when you turn the
Secondary Burner On or Off. The flame level can only be changed
in the Flame Level mode.
NOTE: The "AUX" function is not available and shall be skipped over.
39
Advertisement
Table of Contents
