Table of Contents
Advertisement
BEFORE YOU BEGIN
Read this entire manual before you use your new fireplace insert(especially the section "Safety Precautions"). Failure to
follow the instructions may result in property damage, bodily injury, or even death.
Remote Control Transmitter Functions
NOTE: The Wall Receiver will "beep" once every time
a Remote Transmitter Key is pressed, signaling that
the command has been received.
Identify the four function buttons on the Remote
Transmitter:
1. ON/OFF KEY: This button turns
the system ON or OFF. When
this button is pressed and the
system is OFF, the pilot light
will stay ON if the "Standing Pilot Switch" is in
the ON position.
2. THERMOSTAT KEY: This button, when pressed after the ON/OFF KEY is pressed and the
system is ON, will allow the selection of three modes: Manual Operation, Normal Thermostat
and Smart Thermostat.
1. Manual Mode: In this mode, the room temperature is ignored and the fireplace can be turned ON indefinitely. The
f i r e - p a r t s . c o m
room temperature rise has no effect on this mode. All other functions such as fan speed control, flame height
control, secondary burner On/OFF control and Accent Light ON/OFF controls will be manually controllable.
2. Normal Thermostat: In this mode, the fireplace will
stay functioning until the room temperature increases
o
1
F above the Set Point Temperature. To increase the
Set Point Temperature, Press the UP button until the
desired temperature is displayed in the SET POINT
TEMPERATURE window. The fan will turn on 5
minutes after fireplace startup and will turn off 12-1/2
minutes after the flames turn off, in this mode. The
flame height can be adjusted while the fireplace is func-
tioning, fan speed can be adjusted after 5 minutes of
startup. Secondary burner can be turned On or Off at
any time after startup. The Accent Light can be turned
on or off any time after startup.
3.
Smart Thermostat: In this mode, all other functions
except the flame height adjustment are allowed. Manu-
al flame height adjustment is not allowed in this mode.
The Smart Thermostat function adjusts the flame height in accordance to the difference between the set point
temperature and the actual room temperature. As the room temperature gets closer to the set point temperature,
the Smart Function automatically modulates the flame down.
3. UP/DOWN KEY: This key is used to increase or decrease the Set Point Temperatures, Flame
Height and Fan Speed and to toggle between Accent Light ON/OFF and Secondary Burner
ON/OFF.
4. MODE SELECTION KEY: This key is used to toggle between the various function icons: Set Temperature, Flame Height
and Secondary Burner.
Setting Pilot to IPI versus CPI mode:
With the remote transmitter OFF, press the MODE button. You will see
either "CPI" or "IPI" displayed on the transmitter screen. Press the UP
arrow button to set "CPI" mode and press the DOWN arrow button to set
"IPI" mode. One set to the desired setting, press On/Off button to activate
the fireplace.
OFF
F
76°
OFF
Hi
MAX
MANUAL
MODE
38
SMART
ON
F
76°
ON
SMART
Hi
68
MAX
NORMAL
SMART
THERMOSTAT
MODE
F
76°
Advertisement
Table of Contents
