Kioti CK22 Instruction Manual page 98

! ! ! ! !
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore changing oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and
can burn.
1. Place the oil pan under the engine.
2. Remove the oil filter.
3. Put a film of clean engine oil on the
rubber seal of the new filter.
4. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter, by hand, an additional
half turn only.
5. After the new filter has been
replaced, the engine oil normally
decreases a little. Make sure that the
engine oil does not leak through the
seal and be sure to check the oil level
on the dipstick. Replenish the engine
oil up to the prescribed level if
necessary.
ADJUSTING CLUTCH PEDAL
(MANUAL)
(1) Clutch Rod (2) Nut
(A) Free Travel
Proper clutch pedal
free travel (A)
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and
measure free travel at top of pedal
stroke.
3. If adjustment is needed, loosen the
051OA12C
lock nut, remove the clevis pin and
adjust the rod length within accept-
able limits.
4. Retighten the lock nut and replace
the clevis pin.
10
PERIODIC SERVICE -9
0.8 ~ 1.2 in.
(20 ~ 30 mm)
on the pedal