Kioti CK22 Instruction Manual page 114

EVERY 2 YEARS
FLUSH COOLING SYSTEM
AND CHANGING COOLANT
(1) Drain Cock
IMPORTANT
Do not start engine without
coolant.
Use clean, fresh water and anti-
freeze to fill the radiator and re-
covery tank.
When the anti-freeze is mixed
with water, the anti-freeze mix-
ing ratio must be less than 50%.
Securely tighten radiator cap. If
the cap is loose or improperly
fitted, water may leak out and
the engine could overheat.
051OA40C
(1) Recovery Tank
(2) Radiator Cap
! ! ! ! !
To avoid personal injury:
Do not remove the radiator cap
when the engine is hot. Then
loosen cap slightly to the stop to
relieve any excess pressure be-
fore removing cap completely.
1. Stop the engine and let it cool.
2. To drain the coolant, open the radi-
ator drain cock and remove radia-
tor cap.
051OA41C
(A) FULL
(B) LOW
CAUTION
PERIODIC SERVICE
The radiator cap must be removed
to completely drain the coolant.
3. After all coolant is drained, close
the drain cock.
4. Fill with clean water and rust
inhibitor.
5. Follow the rust inhibitor manufac-
ture's instructions.
6. After flushing, fill with clean water
and anti-freeze until the coolant lev-
el is just below the port.
Install the radiator cap securely.
7. Fill with coolant up to the "FULL"
mark on the recovery tank.
8. Start and operate the engine for few
minutes.
9. Stop the engine and let cool.
10. Check coolant level of recovery
tank and add coolant if necessary.
CK22
Coolant 1.50U.S.gals.
capacity
(2.7 )
CK22H
10
-25