6
-4
CK22
(1) Turn Buckle
(3) Nut
(2) Check Chains
CHECK CHAINS
Check chains are used to adjust the
side sway that your implement has
while in use. Check Chains are also
used to center the implement on the
rear of the tractor.
! ! ! ! !
WARNING
Use caution when adjusting the
check chains. Heavy implement
can move causing harm.
To adjust the check chains, loosen the
set nuts and twist the turn buckles on
both sides until the desired amount of
sway is reached. Set the adjustment
by tightening the set nuts against the
051O604C
turn buckles.
DRAWBAR
ADJUSTING DRAWBAR LENGTH
(1) PTO Shaft
(3) Drawbar Pin
(2) Drawbar
(A) Holes
! ! ! ! !
WARNING
To avoid personal injury:
Never pull from the top link, the
rear axle or any point above the
drawbar. Doing so could cause
the tractor to tip over rearward
causing personal injury or death.
The drawbar load is rating is listed in
the "IMPLEMENT LIMITATIONS"
section.
051O605C