Kioti CK22 Instruction Manual page 79

AUXILIARY HYDRAULICS
JOYSTICK VALVE
(T) To the Tank
(P) From the Pump
(A1) A1 PORT
(A2) A2 PORT
(B1) B1 PORT
(B2) B2 PORT
Boom Cylinder : A1,B1
Bucket Cylinder : A2,B2
NOTE
When the lever is at each corner
position marked by*, boom and
bucket cylinders work at the same
time. However, the position marked
by cross is not recommended for
scooping because of insufficient lift
force.
051O706C
To begin test operation, slightly move
the control lever from the "N" position.
Slowly raise the loader boom just
enough for the bucket to clear the
ground when fully dumped. Slowly
work through the dump and roll back
cycles.
IMPORTANT
If the boom or bucket does not
work in the directions indicated
in the label, lower the bucket
to the ground, stop the engine,
and relieve all hydraulic
pressure. Recheck and correct
all hydraulic connections.
FLOAT
DOWN DUMP
& ROLL &
DOWN
BACK DOWN
ROLL
DUMP
BACK
U P U P
& ROLL &
U P
BACK DOWN
051O707C
HYDRAULIC UNIT
This loader control valve has two stage
dump position. The first dump position
by moving the lever to the right is the
"Regular" dump position.
It has good power and control for dump-
ing precisely. This position should be
used when operating another implement
with the loader's control valve.
IMPORTANT
Do not move the control lever
into float position when the
bucket is off the ground.
7
-5