Nfc Communication - NTT docomo DM-01G Instruction Manual

u "Bluetooth" u select a
c
Bluetooth device
• To send multiple photos at a time,
the photo list screen u "Select all" or
place check marks on photos to send
u "Share" u "Bluetooth" u select a
Bluetooth device.
Receive the data by following the
d
on-screen instructions on the device
of the recipient
Receiving data via Bluetooth function
Set this terminal to detectable
a
Tap "Accept" when Bluetooth
b
authorization request screen is
displayed
• appears in the status bar, and data
reception starts.
• You can conirm data reception on the
notiication panel.
• Message screen appears at the bottom
screen after receiving data.

NFC Communication

NFC is short for Near Field Communication.
on
It is an international standard proximity
wireless communication system determined
by ISO (International Organization for
Standardization). This terminal enables non-
contact IC card function, Reader/writer
function (R/W), peer-to-peer communication
function (P2P), etc.
Use NFC function to transfer data with other
compatible devices.
• About notes on holding over device → P142
Android Beam
You can transmit and receive data with a device
equipped with Reader/Writer, P2P functions.
• Activate Reader/Writer, P2P functions
beforehand, and turn the "Android Beam" ON.
• If NFC/Osaifu-Keitai is set to lock, Android
beam cannot be used.
• Depending on the application, Android beam
may not be used.
• We do not guarantee any communication with a
terminal equipped with Reader/Writer, P2P functions.
• If terms of use screen is displayed when
sending or receiving data, conirm the contents
and follow the on-screen instructions.
Data Communication
239