Connecting An External Decoder; Connecting The Ac Power Cord; Connecting Power Supply Cords - Yamaha DSP-AX1 Owner's Manual

Connecting an External Decoder

The DSP-AX1 is equipped with six additional input jacks (left and right MAIN, CENTER, left and right SURROUND and SUBWOOFER)
for discrete multi-channel input from an external decoder, sound processor, or pre-amplifier.
MAIN
DVD
SURROUND
LD
SUB
D-TV WOOFER
6CH INPUT
CBL
/SAT
VCR 1
DIGITAL
L R C
Subwoofer Output
External Decoder
Surround Output

Connecting Power Supply Cords

(General Model)
IMPEDANCE SELECTOR
AC OUTLETS
VOLTAGE SELECTOR
24
CENTER
ZONE 2 OUT VIDEO
OUT
L R
C
Center Output
Main Output

Connecting the AC Power Cord

After completing all connections, plug the AC power cord into a convenient AC
outlet.
AC Power Cord
AC OUTLETS
Use these to connect the power cords from your other components to this unit.
The power to the switched outlets is controlled by this unit's STANDBY/ON
(SYSTEM POWER ON or STANDBY on the remote). These outlets will
supply power to any connected unit whenever this unit is turned on. The
AC OUTLETS
maximum power (total power consumption of components) that can be connected
to AC OUTLETS is 100W.
VOLTAGE SELECTOR (General and China Models)
VOLTAGE
The voltage selector on the rear panel of this unit must be set for your local
SELECTOR
voltage before plugging into the AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
Hookups
Connect the output jacks on your external decoder to the 6CH
INPUT jacks.
Be sure to match the left and right outputs to the left and right input jacks for
the main and surround channels.
To listen to the sound from your external decoder, press 6CH INPUT on this
unit or the remote control.
Note:
• When you select 6CH INPUT as the input source, this unit automatically turns off
the digital sound field processor, and you cannot listen to DSP programs.