Clearing Learned Functions, Macros, Renamed Displays,
and Manufacturer Setups
For example, when DVD is selected as
the source component.
• If the remote control is without batteries for more than twenty minutes, or if worn out batteries remain in the unit, the contents of the memory may be
When the memory is cleared, insert new batteries and program any acquired functions that may have been cleared.
• "ERROR" appears in the display window for the following conditions: when pressing a button other than the cursor and ENTER; when pressing more than
one button at once; and when one of MACRO ON/OFF, 10KEY/DSP, PARAMETER/SET MENU is switched to another position.
Remote Control Features
Press CLEAR using a ballpoint pen or similar object.
to select the clear mode. The mode is shown
in the window in the following order:
(L: name of a component) Clears all
learning functions of the component.
Clears all learning functions of the
main unit control area (see page 50).
Clears all learning functions.
Clears all macros.
Clears all renamed displays in the
Clears all programmed functions
including manufacturer code presets.
This returns to the factory presets.
Press and hold CLEAR again for about 3 seconds.
• "C:NG" appears in the display window if the operation is
Press CLEAR to confirm clearing.
• Once you clear a learned function or macro from a button, the
button reverts to its factory preset function or macro.