Table of Contents
Advertisement
Water hardness
Class
2
3
4
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the four colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water!
3. Shake the strip to remove the excess
of the water.
4. After 1 minute check the hardness of
the water according to the table
below.
The colours of the reaction zones
continue to change after 1 minute.
Do not consider this in the
measurement.
5. Set the hardness of the water in the
menu: Basic Settings.
Test strip
6. DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Navigating the menus
1. Activate the appliance.
2. Press
option.
Calcium deposit
(mmol/l)
dH
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
over 21
over 3.8
Hardness of the
water
1
or
to select the menu
Calcium deposit
(mg/l)
50 - 100
100 - 150
over 150
Test strip
The black squares in the table
correspond to red squares on the test
strip.
You can change the hardness level of the
water in the menu: Basic Settings / Water
hardness.
After a power cut you do not have to set
the hardness level of the water again.
3. Press
to move to the submenu or
accept the setting.
At each point you can go
back to the main menu with
.
ENGLISH
11
Water classi-
fication
Moderately
hard
Hard
Very hard
Hardness of the
water
2
3
4
Advertisement
Table of Contents
