Table of Contents
Advertisement
Operating the Charger
The following is a step-by-step guide for operating the RDX1 Pro. The screen
shots and operation templates shown below are for the operation of a LiPo
BALANCE CHARGE program . Refer to the Available Operations chart on
page 13 and 14 to setup your specific type of battery.
Whenever a parameter value in the program needs to be adjusted, highlight
the value by pressing the START/Enter button to make it blink; to change
the value press the DEC or INC buttons. The new value will be stored by re-
pressing the START/Enter button. If there is another parameter to be adjusted
as part of a range on the same screen, it will start blinking after the first
parameter value has been confirmed.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
INFORMATION CONTAINED ON PAGES 3-7.
Warning
WARNING
NEVER LEAVE CHARGER
UNATTENDED. BATTERY CHARGING
CAN BE DANGEROUS. PRESS ENTER
TO CONFIRM YOU HAVE READ
THE MANUAL & WARNINGS AND
UNDERSTAND THEM.
PROGRAM SELECT(01)
C Current
Battery Type:
Battery Cells:
Mode:
Balance
WARNING
This warning will first appear on the screen prior
to having full use of the charger. Press ENTER to
acknowledge you have read and understood all
warnings before using this charger.
BATT/PROGRAM Select
3.3A
LiPo
Press INC and DEC to cycle through all battery
types and press START/ENTER to select the
3S
appropriate battery types to be charged.
*NOTE: WHEN IN IDLE MODE, BACKLIGHT TURNS OFF
15
Advertisement
Table of Contents
