Warnings And Safety Notes - HITEC 44246 Instruction Manual

Warnings and Safety Notes

Warning
Note Caution
These warnings and safety notes are of the utmost importance. You must
follow these instructions for maximum safety. Failure to do so can damage the
charger and the battery and in the worst cases, may cause a fire.
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS CONNECTED
TO ITS POWER SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE
Warning
THE PROCESS AT ONCE AND REFER TO THE OPERATION MANUAL.
A
The allowable AC input voltage is 100 - 240V AC
A
The allowable DC input voltage is 11-18V DC.
A
Keep the charger away from dust, damp, rain, heat, direct sunlight and
excessive vibration.
A
If the charger is dropped or suffers any type of impact, it should be
inspected by an authorized service station before using it again.
A
This charger and the battery should be put on a heat-resistant, non-
flammable and non-conductive surface.
A
Never place a charger on a car seat, carpet or similar surface. Keep all
flammable volatile materials away from the operating area.
A
Make sure you know the specifications of the battery to be charged or
discharged to ensure it meets the requirements of this charger. If the
program is set up incorrectly, the battery and charger can be damaged.
A
Fire or explosion can occur due to overcharging.
A
To avoid a short circuit between the charge lead, always connect the
charge cable to the charger first, then connect the battery. Reverse the
sequence when disconnecting.
4
Warning: Be sure to read this section for your own safety.
Caution: Be sure to read this section to prevent accidents
and damage to your charger.
Tip
Tip: This section will help you maximize the performance of
your charger.
Note: This section will provide more detailed explanations.