Table of Contents
Advertisement
INSTALLATION
Installation
The cooker hood is supplied with
2 pipe conectors Ø l25 mm or Ø l52 mm
3 Spacer (F, H)
4 Screws (C)
2 Bulbs (LED)
To fixing the Hood, use the 4 screws (C)φ6mm supplied with the hood.
Close the space that remains between the hood and the wall, adjusting the spacer (F).
Before completing any connection, make sure the house voltage corresponds with the
voltage indicate on the data label.
Connecting the hood to the grid
Warning: before connecting the hood: switch off the electricity supply and check
that the supplied voltage and frequency coincide with that indicated on the appliance
nameplate.
If the extractor hood has a plug, connect it to a power socket in line with applicable
regulations, located in an accessible area.
If the terminals of the plug are unmarked or if you are in any doubt consult a qualified
electrician.
If it is not supplied fit a plug normalized in the cord for the load showed on the rating label.
P.5
Advertisement
Chapters
Table of Contents
