IBM xSeries 306m Problem Determination And Service Manual page 74

5. Use the thermal-grease syringe to place 16 uniformly spaced dots of 0.01 mL
6. Install the heat exchanger onto the microprocessor as described in "Installing
58
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide
Microprocessor
each on the top of the microprocessor.
Note: 0.01mL is one tick mark on the syringe. If the grease is properly applied,
approximately half (0.22 mL) of the grease will remain in the syringe.
the microprocessor" on page 56.
0.01 mL of
thermal grease