System-Error Log Messages - IBM xSeries 306m Problem Determination And Service Manual

10. Remove the diskette from the diskette drive.
11. Disconnect all power cords; then, remove the server cover.
12. Return the boot block recovery jumper to pins 1 and 2.
13. Reinstall the server cover; then, reconnect all external cables and power cords
14. Turn on the server to restart the operating system.

System-error log messages

A system-error log is generated only if a Remote Supervisor Adapter II is installed.
The system-error log can contain messages of three types:
Information
Warning
Error
Each message contains date and time information, and it indicates the source of
the message (POST/BIOS or the service processor).
In the following example, the system-error log message indicates that the server
was turned on at the recorded time.
The following table describes the possible system-error log messages and
suggested actions to correct the detected problems.
Note: These actions have the following meaning:
Reseat the system board
100
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide
7. Insert the POST/BIOS update (flash) diskette into the diskette drive. You can
download a file to create this diskette from http://www.ibm.com/support/.
8. Turn on the server and the monitor.
9. After the update session is completed, turn off the server and monitor.
and turn on the peripheral devices.
Information messages do not require action; they record significant
system-level events, such as when the server is started.
Warning messages do not require immediate action; they indicate
possible problems, such as when the recommended maximum
ambient temperature is exceeded.
Error messages might require action; they indicate system errors,
such as when a fan is not detected.
- - - - - - - - - - - - - - - - - - - - - - - - -
Date/Time: 2002/05/07 15:52:03
DMI Type:
Source: SERVPROC
Error Code: System Complex Powered Up
Error Code:
Error Data:
Error Data:
- - - - - - - - - - - - - - - - - - - - - - - - -
(Trained service technician only) Complete the following steps:
1. Disconnect all cables from the system board.
2. Remove all removable components from the system board, including
the microprocessor; then, remove the system board from the chassis
(see "Removing the system board" on page 59).
3. Check the system board for damage or loose parts.
4. Make sure the system board area in the chassis is free of objects; then,
replace the system board in the chassis (see "Installing the system
board" on page 60).