Powering On/Off The Projector; Connecting The Power Cord; Power Indicator - Panasonic PT-VW530 Operating Instructions Manual

Powering on/off the projector

Connecting the power cord

Make sure that the supplied power cord is securely fixed to the projector body to prevent it from being removed easily.
For details of power cord handling, refer to "Read this first!". (x page 2)
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction (until you hear the side tabs click in
place).
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.

Power indicator

Displays the status of the power. Check the <ON (G)/STANDBY (R)> status of the power indicator before operating the
projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status
Off
Lighting
Red
Blinking
*1
Orange Lighting
Lighting
Green Blinking
*2
Blinking
*3
*1 The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
Chapter 3 Basic Operations - Powering on/off the projector
The power cord is unplugged.
The power is switched off (in standby mode). The [ECO MANAGEMENT] x [STANDBY MODE]
is set to [ECO].
The power is switched off (in standby mode). The [ECO MANAGEMENT] x [STANDBY MODE]
is set to [NORMAL].
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
Projecting.
The power is on and the lamp is not working. The [ECO MANAGEMENT] x [POWER
MANAGEMENT] is set to [READY].
The lamp starts work. The projector will project image after a while.
Status
ENGLISH - 35