[Eco Management]; [Normal] - Panasonic PT-VW530 Operating Instructions Manual

f The items will switch each time you press the button.

[NORMAL]

[ECO]
Note
f Set it to [ECO] rather than [NORMAL] when you want to reduce power consumption, extend the life of lamp and reduce
operation noise.

[ECO MANAGEMENT]

This function optimizes lamp power according to the operating status to reduce power consumption.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select the item.
Setting [AUTO POWER SAVE] in step 3)
Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION].
4) Press qw to switch the [AUTO POWER SAVE].
[OFF]
[ON]
5) Press as to select one item.
[AMBIENT LIGHT DETECTION] Adjusts the power of the lamp according to the brightness of the installation location.
[SIGNAL DETECTION]
[AV MUTE DETECTION]
6) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f Lamp power cannot be reduced automatically in the following cases:
- When the lamp lit or the setting of [LAMP POWER] is completed, etc..
f When [AUTO POWER SAVE] is set to [OFF], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], [AV
MUTE DETECTION] are unavailable.
f When objects, etc. are placed around the luminance sensor on the top of the projector, [AMBIENT LIGHT DETECTION] may
not function properly.
Setting [POWER MANAGEMENT] in step 3)
Set the operation as following if there is no signal input.
1) Press as to select [POWER MANAGEMENT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Power management function is off.
The countdown timer is displayed after 30 seconds without input signal. The projection lamp turns off
[READY]
and cools down when reaching the set time, meanwhile the projector is in the power management
mode. The projection lamp will be turned on if the input signal is reconnected or any button is pressed.
The countdown timer is displayed after 30 seconds without input signal. The projection lamp is turned
[SHUT DOWN]
off and cooled down when reached the set time, then the projector enter into standby status.
Setting [TIMER]
The timer can be set to 5-120 minutes. The increment is 5 minutes.
1) Press as to select [TIMER].
72 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Select when high luminance is required.
Select when high luminance is not required.
Disables the energy conservation setting.
Enables the energy conservation setting.
Lowers the power of the lamp when there is no signal.
Lowers the power of the lamp when the [AV MUTE] is [ON].
Disables above setting.
Enables above setting.