Connecting; Before Connecting - Panasonic PT-VW530 Operating Instructions Manual

Connecting

Before connecting

f Before connecting, carefully read the operating instructions for the external device to be connected.
f Turn off the power switch of the devices before connecting cables.
f Take note of the following points before connecting the cables. Failure to do so may result in malfunctions.
- When connecting a cable to a device connected to the projector or the projector itself, touch any nearby metallic objects to
eliminate static electricity from your body before performing work.
- Do not use unnecessarily long cables to connect to a device connected to the projector or to the projector body. The longer
the cable, the more it is susceptible to noise. Since using a cable while it is wound makes it act like an antenna, it is more
susceptible to noise.
- When connecting cables, connect GND first, then insert the connecting terminal of the connecting device in a straight
manner.
f If any connection cable is not supplied with the device, or if no optional cable is available for connection of the device,
prepare a necessary system connection cable to suit the device.
f Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In this case, a
time base corrector (TBC) must be connected.
f The projector accepts VIDEO signals, Y/C signals, YC
TTL level), and digital signal.
f Some computer models or graphics cards are not compatible with the projector.
f When using long cables to connect with each of equipment to the projector, there is a possibility that the image will not be
output correctly unless a compensator is used.
f For details on what video signals the projector supports, see "List of compatible signals". (
<COMPUTER 1 IN> terminal pin assignments and signal names
Outside view
<COMPUTER 2 IN/1 OUT> terminal pin assignments and signal names
Outside view
Chapter 2 Getting Started - Connecting
C /YP P
B R B R
Pin No. Signal names
R/P
G/Y/Y
B/P
—
GND
GND
GND
GND
Pin No. Signal names
R/P
G/Y
B/P
—
GND
GND
GND
GND
signals and analog RGB signals (synchronous signals are
Æ
Pin No.
/C
R
B
Pin No.
R
B
page 111)
Signal names
+ 5 V
GND
GND
DDC data
HD/SYNC
VD
DDC clock
Signal names
+ 5 V
GND
—
DDC data
HD/SYNC
VD
DDC clock
ENGLISH - 31