User Settings - Furuno FAR-2218 Operator's Manual

If you selected [UTC], close the menu. If you selected [LOCAL], go to step 6.
6. Select [3 ADJUST LOCAL TIME].
Time indication highlighted as a whole.
Toggle between "+" and "-" is possible.
7. Spin the scrollwheel, or use the number keys to input the desired offset.
The offset must be in 30 minute increments.
Note: Regarding input for [3 ADJUST LOCAL TIME], when using the number
keys, the indication is first selected as a whole. At this time, you can toggle be-
tween plus "+" or minus "-". Press the 8 key for "-", press the 2 key for "+". If single
digits are highlighted, toggle is not possible. In this case, press the CANCEL
TRAILS key to re-highlight the whole indication.
8. Close the menu.
1.15

User Settings

The user functions shown in the table below can be reset to their default settings by
enabling the [PILOT SETTING] option in the [USER SET] menu. Functions not shown
in the table below maintain their previous setting.
The unit can store two separate user settings, for the functions listed below, in the in-
ternal memory. These settings can also be recalled. Functions not shown in the table
below cannot be stored or recalled.
Function
GAIN
SEA
RAIN
TUNE
TX CH
Range
Range rings
VRM1 Display
Distance
VRM2 Display
Distance
EBL1 Display
Bearing
Reference
Setting(s)
Maintained as per [GAIN] box
previous setting.
[AUTO] [SEA] box
[AUTO] [RAIN] box
[AUTO] [TUNE] box (Magnetron radars only)
Maintained as per previous setting. (Solid State radars only)
[6 NM] [RANGE] box
[OFF] [MAIN MENU]
RINGS]
[ON] [VRM1] box
[0.250 NM]
[OFF] [VRM2] box
[0.000 NM]
[ON] [EBL1] box
Maintained as per
previous setting.
Maintained as per [MAIN MENU]
previous setting. EBL•VRM•CURSOR SET]
BEARING]
1. OPERATIONAL OVERVIEW
Single digit is highlighted. Toggle
between "+" and "-" is not possible.
Menu/On-screen box
[3 NAV TOOLS]
[3 NAV TOOLS]
[4 RANGE
[3
[5 EBL•CURSOR
1-23