Installation - HIKVISION DS-2CE56H1T-IT1E User Manual

1.2.3 Overview of Type III Camera
Mounting
Base
Tilt Adjusting
Screw
Bubble
Figure 1-3 Overview of Type III Camera

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with

your required output to avoid damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera and the
bracket.
If the wall is cement, insert expansion screws before

installing the camera. If the wall is wooden, use
self-tapping screw to secure the camera.
If the product does not work properly, contact your

dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in the figure below.
Figure 2-1 Disassemble the Camera
2. Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. Drill the screw holes and the cable hole (optional)
on the ceiling/wall according to the drill template.
IR LED
Photoresistor
Black Liner
Safty Rope
Mark
Notch
Power Cord
12 VDC
Video Cable TVI