HIKVISION DS-2CE56H1T-IT1E User Manual page 7

3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.1.2 Mounting with Inclined Base
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill screw holes, and the cable hole on the
ceiling/wall according to the supplied drill template.
3. Disassemble the inclined base by the screw driver.
4. Install the turret camera's mounting base on the
inclined base cover with three PM4 screws.
Figure 2-7 Install Turret Camera's Mounting Base
5. Install the inclined base's body on the ceiling/wall
with four PA4 × 25 screws, as shown in Figure 2-8.
Figure 2-8 Fix the Inclined Base Body
6. Combine inclined base's cover with its body with
supplied screws.
7. Repeat steps 6 to 9 of the 2.1.1 Ceiling/Wall
Mounting without Junction Box to complete the
installation.
Figure 2-9 Fix the Camera to the Inclined Base
2.2 Installation of Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the turret camera. Ceiling mounting will be taken as
Figure 2-6 The Drill Template
Screw Hole
Cable
Hole