fire or other damage to the equipment. Be sure to use only accessories made by Daikin which are specifically designed for use with the equipment and have them installed by a professional. Ask your dealer to move and reinstall the air conditioner.
Do not operate the air conditioner when using a room fumigation Cautions - type insecticide. Failure to observe could cause the chemicals to become Do not use the air conditioner for other purposes. deposited in the unit, which could endanger the health of those In order to avoid any quality deterioration, do not use the unit for who are hypersensitive to chemicals.
EMOTE CONTROLLER For systems without cool/heat changeover remote control switch (See figure 3) Refer to the operation manual of the remote controller. Press the operation mode selector button several times and select the operation mode of your choice. HANGEOVER SWITCH AME AND FUNCTION OF EACH SWITCH (See figure 2)
Explanation of heating operation For systems with cool/heat changeover remote control switch (See figure 6) It may take longer to reach the set temperature for general heating operation than for cooling operation. Select cooling operation mode with the cool/heat changeover remote control switch.
7.4. Setting the master remote controller NERGY SAVING AND OPTIMUM OPERATION When the system is installed as shown in figure 9 (RXY(H)Q + RXYSQ – the outdoor unit is connected to several indoor units) and Observe the following precautions to ensure the system operates figure 10 (REM(H)Q + REY(H)Q –...
9.2. Maintenance before a long stop period Symptom 6: White mist comes out of a unit (e.g. at the end of the season) Symptom 6.1: Indoor unit Let the indoor units run in fan only operation for about half a day When humidity is high during cooling operation in order to dry the interior of the units.
" Symptom 12: The display shows " If the system goes into fan only operation, but as soon as it goes into heating or cooling operation, the system stops This is the case immediately after the main power supply switch is turned on and means that the remote controller is in normal Check if air inlet or outlet of outdoor or indoor unit is not blocked condition.
Recommended replacement cycle of wear parts WARNING Table 2: "Replacement Cycle" list Do not modify, disassemble, remove, reinstall or repair the unit yourself as incorrect dismantling or Maintenance cycle (replacements and/ installation may cause an electric shock or fire. Component Inspection cycle or repairs) Contact your dealer.