Installing Device Drivers For Unixware; Installing The Files For Openserver 5.0.2 And 5.0.4 - IBM Netfinity ServeRAID-3H Installation And User Manual

Installing the files for OpenServer 5.0.2 and 5.0.4

To install files for OpenServer 5.0.2 or 5.0.4 using an IDE CD-ROM drive:
1. Type the following at the BOOT prompt:
restart link=ipsraid Srom=wd( , , , )
Note: The ATAPI BTLD (which includes the WD driver) is included in OpenServer 5.0.2 and 5.0.4.
The fields for the ATAPI CDROM are:
Srom=wd(c,d,l,b) where:
c = primary (0) or secondary (1) IDE/EIDE controller
d = master (0) or slave (1) device
l = LUN of device (always 0 with ATAPI or WD driver)
b = BUS of device (always 0 with ATAPI or WD driver)
2. Let the system start normally until it comes to the select Media options.
If you are using OpenServer 5.0.2, go to step 3.
If you are using OpenServer 5.0.4, go to step 4.
3. To install with OpenServer 5.0.2:
a. Click Adapter type as WD.
b. Click Media Type as SCSI CDROM.
c. Click ID, BUS and LUN as 0.
4. To install with OpenServer 5.0.4:
a. Select Media Type as IDE CDROM Drive.
b. Select Primary Adapter and Master Device.

Installing device drivers for UnixWare

The instructions that you use for installing the ServeRAID files when using UnixWare depend on the
number of IDE and SCSI disk-storage adapters and controllers installed in the system. If all of the
direct-access-storage devices (DASD) in the system are attached to a single disk-storage adapter or
controller (such as the ServeRAID controller), you can skip the instructions in this section and go directly
to "Installing the files while installing UnixWare" on page 63 or "Installing the files after installing
UnixWare" on page 63.
If you are attaching devices to multiple disk-storage adapters or controllers (including IDE and SCSI
controllers integrated on the system board), use the following instructions. If you are not using multiple
disk-storage adapters and controllers go to "Installing the files while installing UnixWare" on page 63.
If you are installing UnixWare on a drive attached to a ServeRAID controller, follow the instructions in
"Installing UnixWare on a ServeRAID drive."
If you are installing UnixWare on a drive attached to a non-ServeRAID adapter or controller and you
intend to store only data on the drives attached to your ServeRAID controllers, follow the instructions
in "Installing UnixWare on a non-ServeRAID drive" on page 62.
Installing UnixWare on a ServeRAID drive: Use the following instructions if you are using multiple
disk-storage adapters or controllers and you are installing UnixWare on a drive attached to a ServeRAID
controller. If you not using multiple disk-storage adapters and controllers, go to "Installing the files while
installing UnixWare" on page 63.
1. Install all ServeRAID controllers that you intend to use in your system.
60
IBM ServeRAID-3H, ServeRAID-3HB, and ServeRAID-3L, Controllers