Elation VOLT Q5E SIX PACK User Manual page 17

SYSTEM MENU
EDIT PROGRAM
A Primary unit can send up to 3 different data groups to the Secondary units, i.e. a Primary unit
can start 3 different Secondary units, which run 3 different programs. The Primary unit sends
the 3 program parts in a continuous loop.
AUTO PRO
PART 1
PART 2
PART 3
The Secondary unit receives data from the Primary unit according to the group which the
Secondary unit was assigned to. If e.g. a Secondary unit is set to "Secondary 1" in the menu
"SetSecondary", the Primary unit sends "Prog 1" to the Secondary unit. If set to "Secondary
2", the Secondary unit receives "Prog 2". To start an Auto Program proceed as follows:
1. Secondary Setting
Select "FuncMode".
Press ENTER to confirm.
Select "SetSecondary".
Press ENTER to confirm.
Select "Secondary 1", "Secondary 2" or "Secondary 3".
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
2. Automatic Program Run
Select "FuncMode".
Press ENTER to confirm.
Select "AutoProg".
Press ENTER to confirm.
Select "Primary" or "Alone".
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
3. Program Selection for Auto Pro Part
Select "EditProg".
Press ENTER to confirm.
Select "Sel Prog".
Press ENTER to confirm.
Select "ProPart1", "ProPart2" or "ProPart3", and select which Secondary program is to be
sent. Selection "Prog 1" means, that the Secondary unit runs the same program as the primary
units.
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
– Record Controller – Working With Built In Programs
AUTO PRO
PART 1
PART 2
PART 3
17
AUTO PRO
PART 1
PART 2
PART 3