Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
DO NOT TOUCH the fixture housing during operation. Turn OFF the power/battery and allow
approximately 15 minutes for the fixture to cool down before serving.
DO NOT shake fixtures, avoid brute force when installing and/or operating fixtures.
DO NOT operate fixtures or road case if the power cord is frayed, crimped, damaged and/or if
any of the power cord connectors are damaged and do not insert into the fixture or road case
securely with ease. NEVER force a power cord connector into the fixture or road case. If the
power cord or any of its connectors are damaged, replace it immediately with a new one of
similar power rating.
ALWAYS disconnect fixture from main power source before performing any type of service and/
or cleaning procedure. Only handle the power cord by the plug end, never pull out the plug by
tugging the wire portion of the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the interior of
the fixture. This is a normal process and is caused by excess paint in the interior of the casing
burning off from the heat associated with the lamp and will decrease gradually over time.
Consistent operational breaks will ensure fixture will function properly for many years.
ONLY use the ROAD CASE to transport all 6 fixtures in for service. If you have a need to send
less than 6 fixtures, please contact ELATION SERVICE for packaging instructions.
BATTERY USE
DO NOT EXPOSE BATTERY TO EXTREME HOT OR COLD TEMPERATURES.
DO NOT EXPOSE BATTERY TO WATER OR WET ENVIRONMENTS.
KEEP FLAMMABLE MATERIALS AND/OR FIRE AWAY FROM THE BATTERY.
DO NOT OPEN AND/OR DISASSEMBLE THE BATTERY.
DO NOT TOUCH AN EXPOSED OR LEAKING BATTERY WITH BARE HANDS.
DO NOT USE A DAMAGED BATTERY IN THE FIXTURE.
TRANSPORT BATTERY ACCORDING TO ALL APPLICABLE LAWS AND REGULATIONS.
DISPOSE OF BATTERY ACCORDING TO ALL APPLICABLE LAWS AND REGULATIONS.
BATTERY CHARGING
PROTECTION CLASS 1 – CHARGING ROAD CASE MUST BE PROPERLY GROUNDED.
DO NOT PLUG CHARGING ROAD CASE INTO A DIMMER PACK.
DO NOT STACK CHARGING ROAD CASES WHILE CHARGING.
DO NOT MOVE CHARGING ROAD CASE WHILE CHARGING.
DO NOT CLOSE CHARGING ROAD CASE LID WHILE CHARGING, IT MUST REMAIN OPEN.
DO NOT LEAVE CHARGING ROAD CASE UNATTENDED WHILE CHARGING.
DO NOT EXPOSE CHARGING ROAD CASE TO RAIN AND/OR MOISTURE. INDOOR / DRY USE ONLY.
DO NOT CHARGE BATTERY IF THE FIXTURE HAS BEEN DROPPED AND/OR DAMAGED.
DO NOT SHORT THE POSITIVE BATTERY TERMANAL PIN, THIS WILL CAUSE DAMAGE.
DO NOT TOUCH BATTERY WHILE CHARGING, AS IT MAY BE HOT WHICH IS NORMAL.
DO NOT CHARGE THE BATTERY FOR MORE THAN 24 HOURS.
CHECK THE CHARGER POWER AND STATUS LED INDICATORS ROUTINELY.
UNPLUG POWER FROM CHARGING ROAD CASE BEFORE HANDLING FIXTURES.
BATTERY STORAGE
STORE BATTERY AT ROOM TEMPERATURE.
STORE CHARGING ROAD CASE IN A DRY ENVIRONMENT, AWAY FROM DIRECT SUNLIGHT.
DO NOT STORE FIXTURES IN CHARGING ROAD CASE WHEN BATTERIES ARE FULLY DRAINED.
TORE BATTERY ACCORDING TO ALL APPLICABLE LAWS AND REGULATIONS.
7
Advertisement
Table of Contents
