Internal Wireless Dmx Receiver Setup - Elation VOLT Q5E SIX PACK User Manual

I N T E R N A L W I R E L E S S D M X R E C E I V E R ( E W D M X )
The VOLT Q5E™ is equipped with an internal Elation Wireless DMX Receiver, which is fully
compatible with an Elation Wireless DMX System.
WORKING WITH THE INTERNAL WIRELESS DMX (EWDMX) System
Access the "WDMX" sub menu from the "PERSNAL" menu. The "WDMX" sub menu allows you to
"ActWDMX" turn the system ON, "AcDaOut" turn the system ON and send DMX data out through
DMX OUT port, "WDMXOff" turn the system OFF, or "ClrWDMX" clear the EWDMX system.
When the EWDMX system is in the "ActWDMX" mode, the internal DMX "IN" XLR jacks are
turned OFF. However the internal DMX "OUT" XLR jacks will function normally. If the fixture
is powered ON with the internal EWDMX system "ActWDMX", it will automatically scan for
a wireless DMX signal from an Elation Wireless DMX Transmitter. If NO wireless signal is
received, it will switch to the wired DMX mode.
NEVER connect a fixture to a controller via a DMX cable when the EWDMX system
is in use. This could cause serious damage to the controller!
SETTING UP THE EWDMX SYSTEM
Follow the instructions included with the Elation EWDMX Transmitter and connect it to the
output of your DMX controller.
To sync your fixture with the Elation EWDMX Transmitter follow the steps below:
Initially, the EWDMX indicator on the fixture should be solid RED.
Press and hold the configuration button on your EWDMX Transmitter for about 3 seconds. The
RED/GREEN LED indicators on the EWDMX Transmitter and the fixture should then begin to
flash rapidly for 5~ 10 seconds while the two systems pair.
Once the fixture is paired with the EWDMX Transmitter (T1), the EWDMX status indicators
on the both the fixture and the EWDMX Transmitter will stop flashing and glow solid
If paring is unsuccessful repeat the process until paring is secured.
The fixture will store the pairing information inside a nondestructive memory bank once a link is
created between the fixture and an EWDMX Transmitter. The fixture will remember the paired
EWDMX Transmitter even if the fixture is turned OFF for extended periods of time.
WARNING!
19
GREEN.