Elation VOLT Q5E SIX PACK User Manual page 16

S YS T E M M E N U
PERSNAL - Stat Set - Addr DMX
When ON, define the desired DMX address via an external controller.
NOTE: This process assumes the fixture DMX address is set to 001. If fixture DMX address is not at 001, you must
adjust the channel numbers accordingly in order for this feature to work. For example: if your fixture address
is 010, then Channel 1 becomes Channel 10, Channel 2 becomes Channel 11, and Channel 3 becomes Channel 12.
1. Connect the fixture to the external controller and power ON.
2. Set the DMX value of Channel 1 on the controller to (7).
3. Set the DMX value of Channel 2 on the controller to (7) or (8). When set to (7), the DMX
address can be set between (1) and (255). When set to (8), the DMX address can be set
between (256) and (511).
4. Using Channel 3 on the controller set the desired DMX address of the fixture.
Example 1: If the desired DMX address is 57, set Channel 1 to a value of (7), set Channel
2 to a value of (7), and then set Channel 3 to a value of (57).
Example 2: If the desired DMX address is 420, set Channel 1 to a value of (7), set Channel
2 to a value of (8), and then set Channel 3 to a value of (164). (256+164=420)
5. 5. After setting Channel 3 to the desired DMX address value, wait for approximately 20
seconds (some fixtures may require a longer time) for the fixture to complete the address
reset function.
PERSNAL - Disp Set – Key Lock
When ON, Control Panel buttons lock automatically after exiting main menu for 15 seconds. To
unlock, keep MODE/ESC button pressed for 3 seconds.
EDITPROG
Sel Prog
Select one of the (10) user defined internal Auto Programs.
EditProg
Edit any of the (10) user defined internal Auto Programs.
EditScen
Edit any of the scenes of the internal Auto Programs.
RecCntrl
The fixture features an integrated DMX-recorder by which you can transmit the programmed
scenes from your DMX-controller to the fixture. Adjust the desired scene numbers via the
encoder (from – to). When you call up the scenes at your controller, they will automatically be
transmitted to the fixture.
16