Table of Contents
Advertisement
Any malfunctions during operation will be identified by an error message on the display�
Proceed as follows in such cases:
F Switch off device using the main switch at front of the device�
F Carry out corrective measures�
F Restart device�
Error code
Cause
Er 03
Temperature inside device (PCB power) too high Heating off
Er 06
Set temperature limit exceeded
Er 21
Safety relay does not open
Er 25
Heater1 error
Er 26
Heater2 error
Er 27
No internal sensor
If the actions described fails to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the service department
- Send the device for repair, including a short description of the fault�
USB 2.0 cable A - B
See more accessories on www.ika.com.
In accordance with IKA warranty conditions, the warranty
period is 24 months� For claims under the warranty please
contact your local dealer� You may also send the machine
direct to our factory, enclosing the delivery invoice and giving
reasons for the claim� You will be liable for freight costs�
Error codes
Effect
Heating off
Heating off
Heating off
Heating off
Heating off
Accessories
Labworldsoft
Warranty
The warranty does not cover worn out parts, nor does it ap-
ply to faults resulting from improper use, insufficient care or
maintenance not carried out in accordance with the instruc-
tions in this operating manual�
Solution
- Switch off device and allow it to
cool down�
- Contact IKA service department�
- Contact IKA service department�
- Contact IKA service department�
- Contact IKA service department�
- Contact IKA service department�
®
18
Advertisement
Table of Contents
