Selecting The Stitch Plate In The User Interface; Thread-Up Command; Embroidery Hoop; Overview Embroidery Hoop Selection - Bernina Kaffe 770 QE PLUS Manual

Embroidering preparation

Selecting the stitch plate in the User Interface

After changing the stitch plate, you can check whether this can be used with the selected needle.
> Tap «Stitch Plate Selection».
> Select the previously fitted stitch plate.

Thread-up command

The machine must be ready for embroidery to bring up the bobbin thread.The bobbin thread can be brought
up in one step for a manual knotting. If no securing stitches are wanted, it is recommended to deactivate the
securing stitches in the Setup.
> Hold the upper thread.
> Push the button«Presser Foot Up/Down».

13.5 Embroidery hoop

Overview Embroidery hoop selection

1

Selecting the embroidery hoop

The best embroidery result is achieved when the smallest possible embroidery hoop for the embroidery motif
is selected.
The embroidery motif has a pre-set size which is displayed.
140
– If the selected stitch plate is suitable to be used in combination with the needle, sewing can begin.
– If the selected stitch plate is not suitable to be used in combination with the needle, an error message
is displayed and starting the machine is automatically prevented.
– The bobbin thread is brought up automatically.
Hoop selection
1