Table of Contents
Advertisement
The Reinforced Darming Program No. 23 is particularly suitable for quick darning of worn areas or tears. The
Reinforced Darming Program No. 23 replaces the longitudinal threads in all fabrics.
If the Darning Program does not cover the whole worn or damaged area, it is recommended to
reposition the work and the sew the Darning Program again. The length is programmed and can be
repeated as often as desired.
> Fit the Buttonhole Foot with Slide #3A.
> Tap «Practical Stitches».
> Select Reinforced darning program No. 23.
> Hoop light-weight materials in the round Embroidery Hoop (optional accessory).
– The darning area stays evenly taut and cannot be distorted.
> Start sewing top left.
> Sew the first row.
> Stop the machine.
> Push the button «Quick Reverse».
– The darning length is programmed.
> Finish sewing the Darning Program.
–
The machine stops automatically.
6.11 Finishing edges
Zigzag No. 2 is suitable for all materials. It can also be used for elastic seams as well as for decorative sewing.
Use darning thread for fine materials. When sewing satin stitch (beads), it is recommended to select a dense,
short the zigzag with a stitch length of 0.3 – 0,7 mm. The satin stitch can be used for appliqué and for
embroidering.
Prerequisite:
•
The edge of the fabric should lie flat and not roll.
> Fit the Reverse Pattern Foot #1C.
> Tap «Practical Stitches».
> Select Zigzag No. 2 or Satin stitch No. 1315.
> Neither select too wide a stitch nor too long a stitch.
> Guide the edge of the fabric into the center of the presser foot, so that the needle goes into the fabric
on one side and over the edge into the air on the other side.
Practical stitches
93
Advertisement
Table of Contents
