Embroidering preparation
> Loosen the fixing screw of the needle using the screwdriver gray Torx.
> Pull the needle down.
> Hold the new needle with the flat side to the back.
> Insert the needle as far as it will go.
> Tighten the fixing screw of the needle using the screwdriver gray Torx.
Selecting the embroidery needle in the User Interface
After changing the needle, you can check whether this can be used with the selected stitch plate.
> Tap «Needle Selection».
> Select the fitted needle.
Selecting needle type and needle size
Convenient memory function: To prevent a loss of information, the needle type and the needle size can be
saved additionally on the machine. The saved needle type and the saved needle size can be checked at any
time.
> Tap «Needle Selection».
138
–
If the selected needle is suitable in combination with the stitch plate, embroidering can be started.
–
If the selected needle is not suitable in combination with the stitch plate, starting the machine is
automatically blocked.