Table of Contents
Advertisement
Information for the doctor on frequent appearance of the
PAD symbol
This device is an oscillometric blood pressure monitor that also
analyses pulse irregularity during measurement. The device is
clinically tested.
The PAD symbol is displayed after the measurement, if pulse
irregularities occur during measurement. If the symbol appears
more frequently (e.g. several times per week on measurements
performed daily) we recommend the patient toseek medical
advice.
This device does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.
4. Data Memory
This model is designed for two users and can store up to 99 blood
pressure readings for each user.
Select either user 1 or 2 by pressing the time button.
Viewing the stored values
Press the M-button 3 briefly, when the device is switched off. The
display first shows «M» AK and «A», which stands for the average of
all stored values.
Pressing the M-button again displays the previous value. Pressing the M-
button repeatedly enables you to move from one stored value to another.
6
Blood pressure readings with suboptimal cuff fit AO-A are not
considered in the average value.
Memory full
Pay attention that the maximum memory capacity of 99 memo-
ries is not exceeded. When the 99 memory is full, the oldest
value is automatically overwritten with the 100th value.
Values should be evaluated by a doctor before the memory
capacity is reached – otherwise data will be lost.
Clearing all values
Make sure the correct user is activated.
If you are sure that you want to permanently remove all stored
values, hold down the M-button (the device must have been switched
off beforehand) until «CL ALL» appears and then release the button.
To permanently clear the memory, press the time button while «CL
ALL» is flashing. Individual values cannot be cleared.
Cancel deletion: press ON/OFF button 1 while «CL ALL» is
flashing.
5. Battery Indicator and Battery change
Low battery
When the batteries are approximately ¾ empty the battery symbol AQ
will flash as soon as the device is switched on (partly filled battery
displayed). Although the device will continue to measure reliably, you
should obtain replacement batteries.
Advertisement
Table of Contents
