Selecting Wrist Position Indicator - Microlife BP W70 Manual

selection will appear on the display first. Press the M-button to select
ON or OFF the MAM mode. Press the Time Button to confirm and
then select the Wrist Position Indicator. To change to standard mode
(single measurement), press the Time Button until the MAM mode
selection menu appears and select OFF.
• The bottom, right hand section of the display shows a 1 or 2 to
indicate which of the 2 measurements is currently being taken.
• There is a break of 15 seconds between the measurements. A count
down indicates the remaining time.
• The individual results are not displayed. Your blood pressure will only
be displayed after all 2 measurements are taken.
• Do not remove the cuff between measurements.
• If one of the individual measurements was questionable, an additional
measurement is automatically taken.

Selecting Wrist Position Indicator

Keeping the wrist at the same height level as heart during
measurement is one of the most important facts to use a wrist blood
pressure monitor. Incorrect wrist position might lead to an inaccurate
result. Follow the instruction of the Wrist Position Indicator to make sure
the wrist height is the same level as heart.
• After the MAM mode is selected, the Wrist Position Indicator ON/OFF
selection will appear on the display. Press the M-button to select ON
or OFF the Wrist Position Indicator. Press the Time Button to confirm
and then enter the date and time setting.
• There are 5 levels of height detection plus a blue LED indicator to
BP W70
help the user determine if the monitor is at the correct height.
• When the monitor is at higher position relative to your heart, 1 or 2
downward arrow(s) appear to remind you to lower the wrist slowly
until the blue LED is lighted with a heart symbol. Conversely, 1 or 2
upward arrow(s) appear when your wrist height is lower to heart level
and raise the wrist higher as indication.
• Adjust your wrist to correct height level and keep about 2 sec, the
monitor will start measurement automatically.
• Please retain this wrist height during measurement, and do not move
even in the interval time of MAM mode until the result displayed on
the LCD.
• The blue LED will blank off during measurement to save the battery
power and appear again with the result when the measurement is
finished.
• If the user doesn't adjust the wrist at correct heart level in time (about
9 sec), the monitor will still start measurement with upward/downward
arrows as an indication. However, we recommend to repeat the
measurement to make sure getting an accurate result.
Caution: The Wrist Position Check is only an approximate indication,
and may not be accurate for all users because of differences in
individual physique and size. If you are unable to make your seat or
table adjustments and find the height of wrist is not same as your heart
level obviously, please turn off the Wrist Position Check feature and
position your wrist at heart level by yourself.
3 EN