Hardware Connection; Confirmation Of Connection Status - Saluki CSA Series User Manual

2.2 Hardware Connection

Insert USB cable's Type-C plug into (1) and insert the AC/DC power adapter's DC plug into (3) on the rear panel. If the power is
OK, the indicator button (2) LED light will light up for 3 seconds. then goes out, indicating the device is in standby mode.
The specification of the power adapter is 220VAC-12VDC/10A. The USB cable is a Type-C to USB-A cable with locking screws,
which meets the USB3.0 standard.
The AC to DC adapter in accessories is 220VAC-12V/10A. The DC socket is a LEMO FGG.1B.302 fast-lock connector. The USB
cable is a Type-C to USB-A cable with locking screws. The cable meets the transfer rate requirement for USB3.1 standard.
If you need the CSA2026 to share the ground with the AC power supply system, you need to connect your ground wire
to the metal part of the CSA2026 case.
Please be sure to fasten the Type-C locking screws. Mass of tests shown that the plug-in force of Type-C socket
cannot guarantee the stable connection in various situations. Please make sure that the USB port of the PC meets the
USB3.0 specification. An unstable connection will cause the software fails to work.

2.3 Confirmation of Connection Status

After connecting the PC correctly, enter the "Device Manager" of the Windows Control Panel to check whether the CSA2026 is
recognized by the system. Three devices should be recognized and works properly, namely Cypress FX3 USB Device, Generic
USB Hub, and USB Mass Storage Device, as shown in Fig. 4.
Fig. 3 Connect the Power Adapter and USB Cable
8
Tel: 886. 909 602 109 Email: sales@salukitec.com
www.salukitec.com