Table of Contents
Advertisement
Option EXM, External Mixing Upgrade Kit
Final Assembly
1. Refer to
Figure
18. Slide the instrument cover back onto the deck from the rear. The seam on
the cover should be on the bottom. Be sure the cover seats into the gasket groove in the Front
Frame Assembly.
2. Replace the four rear feet to the rear of the instrument. Torque the rear feet screws
(0515-1619 and 3050-0893 washers) to 21 inch-pounds.
3. Replace the bottom feet by sliding into place until they snap in. Install the locks by pressing in
flat.
4. Replace the handle straps on both sides of the instrument. Torque the handle strap screws to
21 inch-pounds.
Figure 18
Instrument Outer Cover Replacement
20
Installation Note N9032-90004
Advertisement
Table of Contents
