Placing - Wallbox Supernova Installation Manual

MECHANICAL INSTALLATION

Placing

Material
Assembly Part Size
Foundation Washer DIN 125A M16
Foundation NUT DIN 934 M16 x 500 mm
1.
Move the charging point closer to its final location (check the minimum
distances necessary to open the side and main doors). Follow the safety
measures detailed in the Transport section of this manual to move the charger.
DISCLAIMER
Before placing the Supernova, maake sure no nuts or
washers are screwed to the upper level plate.
2.
Open the side door on the left side of the charger with the key,
then open the front one in order to route the entry cable.
3.
Raise the Supernova with a forklift or a crane and place it
above the four rods that protrude from the ground.
4.
Close only the side door, to facilitate the process.
IMPORTANT
Close the doors carefully, pushing them steadily to make sure
that the electrical components are not damaged.
32
Quantity Tools recommended
4 Not Applicable
4 Spanner (size 24 mm)
MECHANICAL INSTALLATION
Placing
PE
N
L1 L2 L3
N PE
L1 L2 L3
PE
L2 L3 N
L1
L2 L3 N PE
L1
7.
Carefully lower Supernova making sure
to route the electrical cables through
the centre of the charging point.
8.
Screw the 4 M16 washers and the
4 M16 nuts until the Supernova is
completely and firmly anchored.
33