Use Instructions - Tesla TSL-VC-R530 User Manual

Use Instructions

Power on and off the machine
Tap and hold the button to power on the machine. Then, the power indi-
cator is on, and the vacuum cleaner enters the standby state. When the vacuum
cleaner is in a static state, press and hold the
ne and stop the current cleaning task.
Tip: The vacuum cleaner in charging state cannot be powered off.
Start cleaning
Press the button to start cleaning. Then, the vacuum cleaner dynamically
plans the cleaning route according to the map generated after scanning, and
completes cleaning of different zones one by one. In each zone, the vacuum clea-
ner first sweeps the floor along the wall, and then moves in zigzag mode to clean
the remaining part of the zone in an orderly and efficient manner.
Zone 1: Cleaned Zone 2: Cleaned
Zone 4: To be cleaned Zone 3: Cleaning
button to power off the machi-
14
Tips:
•If the power is too low, the vacuum cleaner cannot start cleaning. Therefore,
charge the vacuum cleaner before starting it.
•Before cleaning, tidy up all kinds of wires on the ground (including the power cord
of the docking station). Otherwise, the vacuum cleaner may drag the wires while
cleaning, which may cause power failures of other electric appliance or damage to
items or wires.
•If the cleaning area is less than 2 square meters, the vacuum cleaner will clean the
area twice by default.
•If the power is insufficient in the cleaning process, the main unit will automatically
return to the docking station for charging. After the power is sufficient, the main unit
will automatically return to the interrupted point to continue cleaning (ensure that
you have enabled the resumable cleaning function).