NOTE
Connecting
Cables
NOTE
Connecting to Host
Devices
Connecting to a
Vending Machine
4
Carefully slide the SAM card into the slot, by aligning the card and carefully
sliding into the slot until fully inserted.
Inserting SAM Card
Figure 9
Before inserting the SAM card, position it as shown in
gold contacts facing inward.
The SAM card has a notch on one corner to ensure that it fits into the connector
base in only one way.
5
Close the SAM cardholder.
The UX 410 Controller Unit rear panel holds several interface ports for power and
communications. Use this section to see how the Controller Unit connects to the
Antenna Unit.
To get the correct connection cables, please refer to Accessories and
Documentation.
This section discusses the cable requirements for connecting the Controller Unit
with the following host units:
•
Connecting to a Vending Machine
•
Connecting to a PC
You can connect the Controller Unit to a host vending machine (VM) with any of
the following connection types:
•
USB Type B
•
ETH (LAN)
Connecting Cables
Figure
9, with the card's
UX 410 I
G
NSTALLATION
UIDE
S
ETUP
17